IKIGAI DOKU
← Workshop Notes

I shoved a Raspberry Pi into a Famicom

The goal was a working emulator in a Famicom shell. “Shove a Raspberry Pi in it” is a pretty good description of the finished project, but it leaves out all the CAD and 3D printing that made the idea work.

Working inside an existing shell is a good exercise in designing around something you can’t move. There’s only so much room, and a part that fits in CAD still has to fit the object on your bench.

If you try a project like this, write down which part revision you printed and check the fit before you change the model again. A note as simple as “fits the shell, but check clearance with the cable plugged in” gives you somewhere to start the next time you open the file.

Apparently, I enjoyed this enough to shove another Raspberry Pi into an N64. Pretty neat!

See the other builds →